JOHN LEWIS JLDWS1204
Owner's Manual

Maintenance and cleaning
Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

Cleaning the Filters

3 The filters must be regularly checked and cleaned.
Dirty filters will spoil the wash results. 6.Re-insert the flat filter. 7.Place the fine filter in the micro-filter and fit the two together. 8.Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment.

1 Under no circumstances may the dishwasher
be used without its filters. Incorrect repositioning and fitting of the filters will produce poor washing results.

switched off. 1. Open the door and remove the lower basket. remove the filter system (B).

1 Before cleaning assure that the machine is

Cleaning the Spray Arm Jets
Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water.

2. Turn the handle about ¼ of a turn anticlockwise (A) and 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2).

4. Clean all filters thoroughly under running water. 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly.

3 Do not damage the jet opening.

24